Three phase alternators are connected in star connection
why?
- 13 Answers
- 39170 Views
- Tanfac, I also Faced
- E-Mail Answers
Answer Posted / manish kumar
in a star connection, phase voltage Vph = VL/ (3)^1/2.
1--Since the induced emf in the primary winding of an alternator is directly proportional to the number of turns, a star connected alternator will require less number of turns than a delta connected alternator for the same voltage.
2-- it also requires less insulation bcz its phase is less.
3-- it also help to reduce third harmonic ...
| Is This Answer Correct ? | 5 Yes | 4 No |
Post New Answer View All Answers
What is meant by vector group
i wasted one year for the job after completed my btech what can i say about 1year time in interview
why does rotor rotets?
what is W.T?specify the acceptable range?
can i able to get bhel previous exam question paper?
WHAT IS THE WINDING PROCEDURE OF ELECTRICAL MOTOR
how to calculate the formula of cable size if motor kw is given
how many joint can done in HT line and what is life of the joint
if an insulated power and control cables of a running gas diesel gensets laid direct in an open trench i.e, trench bed is not rcc of a power house in which rain water, spillage water alwas exists and all power control cables remains submerged even when gas gensets of 480 kw each runningin on load. These power &control cables runs from power house to switchgear room through these trenches in which water remains most of the time. pl explain its merit & de-merit
I am completed DEEE in tamilnadu, now i am working in andhrapradesh with 2.5 year experience in relavent field. capacity of the tranformer is 11KV, 1MVA Transformer, i am eligible for getting c licence in andhrapradesh pl help me.
what is the chiller and working principal
1.4 What is meant by CT knee point voltage and how would you determine it
What is a difference between indoor transformer and outdoor transformer of same rating
can anyone please help me to find the rupturing or breaking capacity in KA of circuit breaker (MCCB,VCB,ACB etc) of HT and LT side of a distribution transformer...please help with detailed step by step answer...thank you
how can you calculate fault level ?
