Interested to Buy Any Domain ? << Click Here >> for more details...
I am working in transmission network, one of my 66kv line
having short distance about 6km, when sending end voltage
is 67kv receiving end get 69kv, i want to know that, does
distance affects in this matter, please explain in this
matter & if possible answer me on my mail id,
kaushikkumar.vanavi@getcogujarat.com,
kaushik.vanavi@gmail.com
- 5 Answers
- 7947 Views
- I also Faced
- E-Mail Answers
Answer Posted / mustafa
this is called proximity effect
whenever there is induction exist between conductors in OH
transmission lines this slight change in voltage will be there
try under ground transmission and check.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
There are a trformer and an induction machine. Those two have the same supply. For which device the load current will be maximum? And why?
To make a basic instrumentation amplifier, it takes A One op-amp with a certain feedback arrangement B Two op-amp and seven resistors C Three op-amps and seven capacitors D Three op-amps and seven resistors
Why is the frequency not changed during transformation of electrical energy in a transformer?
I NEED RRB APTITUDE QUESTIONS AND MODEL PAPER,PLEASE SEND MY E-MAIL joo28_eee@yahoo.co.in
should %impedance be high or low in a power transformer? if so why?
how to get bearing & winding temperature of an induction motor?
I want definition for ABT Meter (Availability Based tariff) ?
hi friends ,iam working as genset AVR service engineer in electrical field from past 2 yrs throughout india . i plan to shift in some other job without travelling in same field because i con't travel,i dont know what i do for that so please guide me what job is suited for me,how i can serch the job please anybody helpme iam totally confused
An automatic water heater is an example of which type of control system?
Explain the different methods used in the choice of rotor slots for reduction of harmonic torques in an induction motor.
hi can any body send me syllabus of rrb electrical section engg... and past pepar also of any board...
STATE USE OF ARC RUNNERS & SPLITTERS ?
Hello to all, Please someone can send me HPCL ELECTRICAL Engg. Sample papers to me? Its urjent....my email address is.... raviasiapacific@gmail.com
we are going to install a solar PV site and how can we calculate PV Solar Panel Efficiency, can anybody tell me complete method for its calculation.
if we have a industrial load of 400 kilowatts with 415 volt AC then how much total harmonic distortion (thd%) should be acceptable for steady power system.
