I am an electrical engineer, I found variation in KWH between
DG and EB for Same load for same duration, can any one help me
why this variation arises?
- 1 Answers
- 3076 Views
- I also Faced
- E-Mail Answers
Answer Posted / sheikh
the difference is called parasitic losses. it depends on
distance b/w delivery end and recieving end and dissapiated
current or power of accessories of components b/w generating
end and recieving end.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is trip and closing coil in cb? Why need of them
I have an existing old MCCB. ABB Model SACE, the rating are: Ue = 660 volts, Iu =1250 Amps, 3 poles, Ith (max) =800 amps at 45 deg C. I need a circuit breaker for my 3 phase motors, 380 volts 60 hz. the supplier required the minimum ampacity of the breaker to be 911 amps. can i use this breaker with rating of Iu =1250 amps but Ith = 800amps maximum?
What is Negative Potential Bias
In india, according to trade theory above 5 HP motor reqired star delta starter. But we R connect 11 KV motor with 14MW in Direct to line ( With VCB starter combination) Can U Guess, How it is possible ?????
which type of stability limit is higher,steady state or transient? why?
What is accuracy of a measurement?
hi pal, i am vengatesh from tamilnadu(chidambaram),i have called for the written test for the post of jr executive(ELECTRICAL) of AAI ,I dont know about the question paper pattern,so any kindly help me to face the examination,post me the model question papers and some tips to write my examination to (vengi.annadurai@gmail.com)
WHTA IS LIMT OF LEAKGE CURRENT OF 11 KV 1 CORE 1000SQ.MM. XLPE CABLE.LOAD ON CABLE IS AROUND 600AMP .LENGTH 500 MTRS.
How to calculate the fuse rating depend upon the DC circuit?
What is line resistance of cable & how it can be measured ?
What are the conditions for sustained oscillator or what is backhouse criterion?
How earthing/grounding done in aeroplanes and ships.
A 100KVA SINGLE PHASE TRANSFORMER 10000/200V,50HZ REQUIRES 300V AT HV SIDE TO CIRCULATE FULL LOAD CURRENT WITH LV SHORT CIRCUITED.THE INTAKE IS 1000W.THE % OF REGULATION ON FULL LOAD AT 0.8 PF LAGGING WILL BE HOW MUCH AND THE SECONDARY TERMINAL VOLTAGE ON 0.8 PF LEADING WILL BE
All the socket in a room become very hot, the Wall was also became very hot and the earth conductor also became live, what in your view might be the possible causes?
what is the minimum recommended leakage current of an earthed cable connected to the body or skid of an alternator
