What are the Safety measures in central chiller plant?
Explain them?
- 22 Answers
- 60821 Views
- Carrier, CPIC, HSL, JLL, I also Faced
- E-Mail Answers
Answer Posted / devashish chouhan
(1)Refrigerent Discharge pressure high
(2)Refrigerent Discharge temp. high
(3)Condensar water flow fail.
(4)Chiller water flow fail.
(5)Oil Discharge pressure low.
(6)Compressure motor feed back lost.
(7)Antifreeze.
| Is This Answer Correct ? | 46 Yes | 7 No |
Post New Answer View All Answers
Single line diagram for dbb (double bus bar)system.
what is the formula of starting current of 3phase and 1 phase motor???
how to calculate the breaking capacity of different breakers.
Why do we use center tap transformer that used with portable tools
what is the chemical name and formula of refrigarent R-134a.
what is mean by restructuring power system?
At the starting of dc motor and syn.motor and induction motor high current flowing through the winding. Due to this the windings burnt out. To avoid this different types of starters are used. But incase of transformer what Will be used (At starting no emf is induced in the primary winding)?
What is ferro-resonance in electrical system? Why it occurs and what are measures to prevent it?
sir please send me previous year questions of jspl of electrical section through which i could prepare myself fpr the test.
plz tell me,ht and lt panel terminals in substations explain beiefly
why voltage form factor of PT are increase , when it is ecpected heigher spikes in system. how it is calculated.
What are hrc fuses and where it is used?
I want to know the 'Test voltage' for Tandelta testing of 3.3 / 6.6 / 11 KV Motors. Please explain
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
WHY BLADE & JOW OF ISOLETOR IN SUBSTATION?
