it is used to measure the potial difference between two point?

Answer Posted / wareagle

try volt meter. I hope you are not looking for a job that
involves electricity.

Is This Answer Correct ?    1 Yes 0 No



Post New Answer       View All Answers


Please Help Members By Posting Answers For Below Questions

What is the direction of current flow in ct secondary...means if the current is flowing from P1 to P2 then what will be the direction of current flow in ct secondaryw

1405


how point on wave controller works.

2074


what a function diesel generetaor turbo charger & turbo charger is more heated explain reason ?

1805


What is capacitance?

723


why star point of HT motor not earthed?

1740






describe the Operation of induction generators from bus bars

1801


How maesure earth neutral value & how much maximum value value required in between earth & neutral.

1583


who many types of fire explane with exmple

1736


can we do the star delta connection of capacitor for 3- phase motor starter.

1538


Please clarify 1. Icw: rated short circuit working withstand capacity 2. Icu: Rated ultimate breaking capacity 3. Ics: Rated service short circut withstand capacity 4. other specification of ACB

2289


how will calculate the safe starting current of 3-phase squirrel cage induction motor?

1440


I have a situation to design sub-Distribution board/Panel meant for feeding power sockets. In the incomer CAN i Take TP MCCB with Neutral Link and All the outgoing feeders with to sockets with TP MCCB and Neutral Link? P.S : My System is IT Earthing

1310


to hook up ten 50 amp rv pedastels at a lenth of 600 feet from the service what size will my service need to be and the size of wire will I have to run to each pedastel in series??????

1489


what is the differation bewreen kwh & fundamental kwh in electronic trivector meters

1765


HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.

1446