Answer Posted / simon
V=I*R
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is line resistance of cable & how it can be measured ?
1)what is the function of a frequency inverter? 2)If a few frequency inverter are connected onto a device network,what are the two setting that will ensure the frequency inverter work properly on the network. 3)whats is the name of the input sensor for weigher? 4)How to confirm that the load cellis faulty? 5)Describe briefly the steps to validate that the weigher is working properly? 6)Describe the procedure to validate the flowmeter accuracy? 7)Describe briefly the steps to validate that the tempreture sensor/transformer is working properly. 8)what is the adjustment that need to be done when you are calibrating the temperature transmitter ? 9)what are the safety measures to be taken before disconnecting motor for rewinding. 10)whats is the synchronous speed in rpm of typical 4pole 50hz motor? 11)whats is the formula for kw, ohm's law 12)if a 3phase motor is rated 3kw,415vac,what is it's rated ampere?
What is industrial plc
substation+ plc system
What is negative sequence over voltage element?
In what condition the HT fuse breakes?
3 shows a 415 V, 3-phase generator supplying a 3-phase 415/110 V transformer. Draw the individual and combined impedance diagrams to a base of 10 kVA. Determine the system fault kVA and the fault currents at the 415 V and 110 V busbars for short circuit faults on the transformer input or output terminals. Work in p.u. values of impedances.
what are the basic insulation levels & what its Unit
What are the types of excitation system?
The capacitive reactance of a capacitor of 1/(2(PI)) F at 10^3 H is
what is data block in plc ? How the values of data block are written and read by hmi ? what is the difference between function and function block ?
why EMF IS INDUCED IN A CONDUCTOR WHEN FLUX LINKING WITH IT CHANGES ACCORDING TO FARADAYS LAW.
What is the basic principal, by which DC voltage level is increased more than the supplied AC voltage during conversion. As upto AC level it is contorrled by firing anlge but after maximum level how is it possible.Please clear picture. OR we have to supply the higher level AC?
Where I can get the sample question for post of Junior engineer electrical-II For RRB Bhubaneswar.
What is the permissible limit of shaft voltage for 6.6 KV motors ? Why? Is there any standard is available?
