Why we use the double acting control valve in flow line?
Answer Posted / afroz
I need answer
Is This Answer Correct ? | 0 Yes | 4 No |
Post New Answer View All Answers
which processor is used in dcs.
What is the use of each wire in three wire RTD
give eg of how I/P is used in control loops
Why do we floating DC in DC system.
Explain the mechanism behind the turbine meter.
How u will setup SPI(2007) on Citrix Server (Thin Client Mode)? Plz Justify?
while i check zero check for dp flow transmitter some fluctuating came (0 to 458 kg/h) what is the reason?
PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear
Hi Friends , i need one urgent help , i am preparing for M.tech entrance examination , i need some obejective questions related to instrumentation field. where can i get those ? can anyone help me pls ?
How to work temperature gauge?
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
Specify eight technical requirements that you would consider important, when deciding upon a particular control valve?
how to relay switch sense the fault?
what is the different between deflection type measurement and null type measurement in RTD?
in natural gas indirect water bath heater,how to prevent the problem of backfire from firetube during ignition...becoz of this backfire performance of wbh is going low.