how much quantity of bending wire required for 1sqmts
- 6 Answers
- 9723 Views
- BUP, Jade Software, I also Faced
- E-Mail Answers
Answer Posted / n.ranjithkumar
0.004Kg
| Is This Answer Correct ? | 10 Yes | 3 No |
Post New Answer View All Answers
Define What is a kip?
What is the difference in painting using Roller and Brush? What is the paint consumption difference? As per IS one coat of painting is painting from left to right and top to bottom whether this can be done using roller ( Roller Stick height and feasibility) ?
Different sizes of Hollow blocks and its weight. Thanks.
how will remove spiderweb cracking in plaster ? what the reasone of make it ?
Curvature ki quantity kaise nikalte hai pls give me ans... curvature canal ka hai
Are you ready to relocate with your immediate family to United States as a new employee?
what are the challenges of being a team leader and a supervisor?
As per Kandal suggestions, we have implemented rolling starts on 140 (+/- 5) degrees and we kept 3 rollars to complete the rolling before falling 125 degrees and the Aggregate AIV is below 22. But When the DBM bed is being rolled 3rd high viabration, (Before 1 plain & low ,2 high Viabrations), the aggregate is getting sharp edge agg. projections are damaged. As the literature is said that, the VG-30 Grade having better control the temp. susceptibility than Penetration grade. if so we could not get this problem at site. But we are facing on site. let me know.
What is the Systematic Responsibility Site Engineer? Who are the above and under co-oridinating ? What is office & Site co-ordination of Site Engineer?
what isload waring calculation
how to calibrate the RM 800
What is the significance of cost estimate knowledge for an architect?
why we use aggregate,sand with cement in concrete?
what is the Purpose of Adding 20% of wet mortar & 1/3rd to Dry Mortar for PCC & Plastering & Rcc .is there any standard method for adding this .?
where tie beam is used? what is the pupose? what dimension of tie beam can provided and number and diameter of steel bars to be used between the columns of 1333mm and 1400.
