why the secondary winding of the transformer is not open circuited ?
Answer Posted / priya
I hope the question relates to current transformer.If the secondary is open circuited,the whole of the primary current will work as magnetising current.A dangerously high voltage will be induced in sec wdg bcoz the sec has large no of turns as compared to primary in CT.And this high voltage gives fatal shocks and for this reason secondary of CT must always be earthed.
Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
I have a CT meter with ratio 60/5. The meter reading of previous month was 3290.49 and that of current month was 3797.26. How many chargeable units as per normal meter should be my reading.
-What should be minimum value of insulation resistance and maximum value of earth resistance at any electrical instillation and what is method of testing the same.
What the main causes of transient interruptions on Over-Head Distribution Lines?
How many types of probe used in cro?
What are the two types of compensation?
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
What is the difference between diesel generator engine with and without turbo charger with the same capacity?
what is plunger and what's the use of it in motor alignment?
i need previous entrence exam papers of nhpc.
what is the star delta connetion and how can do it a three phase motor with control witing with picture
thyristor controlled APFC panel design parameter?
What shall be the secondary output voltage if the primary winding of a 220/6V, 50 Hz transformer is energized by an 110V, 60 Hz supply?
i want bhel placement paper for electrical if anybody having pl send to my id kavitha867@myway.com immediately
what is the formula to calculate voltage drop/loss on 66KV Transmission Line?
How out of step protection relay works?