Interested to Buy Any Domain ? << Click Here >> for more details...
In 3 phase induction motor even with low Voltage it reaches
nearly it's rated speed why? (for example instead of 400V it
reaches with 250V)
- 2 Answers
- 4743 Views
- I also Faced
- E-Mail Answers
Answer Posted / kj
With an induction motor the speed is dependant on the
frequency and is the same as the frequency minus slip. For
a 4 pole motor this is about 1440 to 1460 RPM.
It does not depend on the voltage. The torque is dependant
on the voltage.
A 400 volt motor supplied at 250 volts would not have
anywhere the power output.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is the purpose of bypass mode in energy lighting transformer?
Why is a plain induction motor unsuitable for wide speed control?
What is the purpose of using busbar mounting fuse?
how is find out kwh step by step
how tto ingress mw in turbine explain.procedure ?
y we use neutral,all r told its used to for closed path..k its a just used to closed path,in a transmission line y we put same conductor used n both phase and neutral..if we use less than phase conductor in neutral mean we ll reduce cost its right r wrong..if we use mean any problem occur in transmission line..
Define steady state error.
What size cable (based on voltage drop) is required to supply a 40 A three phase boiler if the wiring system is 75V single insulated cables installed in non-metallic rigid conduit 56m from the main switchboard? Voltage drop in the consumer's mains is 8V.
how to enter inverter parameter? without manaual?
ELECTRICAL ENGINEER TEST IN FEWA ANY ONE HAVE KNOWLEDGE ABOUT THIS?????????
why do we have spikes enough to burn electronic boards, when generators are not grounded
the problem faced on star or delta winding connection??
What are safety device in vcb and acb?
Actually I have a doubt on neutral and earth.we use Ac power without taking neutral by connecting to earth,but at that time does it affects on efficiency of any electrical components or no? If yes how?
why do we use spark detector inside the slip ring brush compartment 0ona slip ring induction motor?
