in split range control valve,two valve should be in two
different line and that should have some distance,and we
have only one positioner feed back link.so how we connect
one feed back in two control valves?if you have picture
please forward me.my email id kb.syamkumar@gmail.com
- 2 Answers
- 6716 Views
- I also Faced
- E-Mail Answers
Answer Posted / ansarru
Not only one positioner.we should have positioner for each valve, that is there are 2 positioners.
Normally one valve work with (4-12) ma and another work with (12-20) and by this way,we are ecoordinating two manipulated variable for a single controlled variable, achieving "SPLIT RANGE CONTRL "
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is Span Error
components of control circuit belongs to control valve
How u will setup SPI(2007) on Citrix Server (Thin Client Mode)? Plz Justify?
In VVVF DRIVES VOLTAGE IS ALSO VARY WITH THE FREQUENCY. HOW? WHAT IS THE DIRECT FORMULA RELATING THESE TWO.
pls give me presant awerness quistion and answer in my emailid.
What is 3 selection available when configure the burnout protection for controller
Please send me the sample question of Instrumentation of hpcl/iocl exam. my mail id hihi_kiholo@rediffmail.com
basic connection and principle of axial shift sensor n differential sensors in tubine describes n draw......
How you calibrate absolute pressure with the calibration range of 0 to 1000 0C Absolute. Please explain the procedure for calibration.
Tr. Wiring for calibration.
while am calibrating Drager polytron 2IR flame gas detector occured non zero status.how can i get zero status?
I have a Control VAlve having size of 2 ".Only the known parameter is Pressure drop . Its 2 Kg. Then How to calculate control valve sizing means Cv.
What is Positive Calibration and Negative Calibration?
how to measure draft pressure in transmitter pl. give its single line digram
what step is taken for ESD ( emergency shut down) in DCS REPLY to hashimka20009@gmail.com
