What is the use of Exciter in generator? & what will be the
current of Exciter in 500 KVA DG Set?
- 2 Answers
- 8782 Views
- I also Faced
- E-Mail Answers
Answer Posted / kj
The above answer is true for DG set also. But sometimes on
small DG the output voltage is used instead of the Pilot
Exciter.
the current will vary with load and also the manufacturer
of the DG.
Often now 1-4 amps but some are 20 to 30 amps.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is an order of a system.
in wind mill use 2100 kw asychronous generator ( induction generator ) rotor voltage : 3300,stator voltage : 690, rpm : 1511 type : MRL063E04 ' we check rotor resistance magger value found following. R-EARTH - 00 M.OHM,Y-EARTH-34 M.OHM,B-EARTH- 33M.OHM R-Y: 31 M.OHM, Y-B: 00 M.OHM,B-R :33 M.OHM HOW CAN I TAKE DECISION?pls ans. quickly
HOW MANY TYPES OF FUSE?
how to find Harmonics and types as per the equipemnts
How to calculate multiplication factor in kva example 500kva ans pls ?
Do any one know exacatly when the results for NHPC held on 8th march 09 for engineering trainees will be released ?. if so please post it, i'm eager to know it.
what is the IS foe lightning arrester?
Is it possible to download the Siemens Selection Chart(TYPE 2 coordination) for 1) fuseless selection 2)Fuse selection
how to calculate single phase motor efficiency ?
How short circuit MVA(Fault MVA) in a power system calculated for calculating number of earth plates ?
what is meant by CT`s saturation ? Can we use Metering CT`s with Protetection CT`s ?
A 100 kVA , 400 v/250 kv testing transformer has 8% leakage reactance and resistance on 100 KVA base . A cable has to be tested at 500 kv using the above transformer as a resonant transformer at 50 hz . if the charging current of the cable at 500 kv is 0.4 A find the series inductance required . Assume 2% resistance for the inductor to be used and the connecting leads . Neglect dielectric loss of hte cable . what will be the input voltage to the transformer ?
what is value of Jin transformer
HOW WE KNOW IN PHYSICALLY THE CONTACT SURFACE OF A VACUUM INTERRUPTER IS GOOD OR GOING TO DAMAGE IN A VCB AFTER ABOVE 500 TIMES OPERATED.
What is meant by load angle of an alternator? Upon what factors does the load angle depend?
