What are the safety devices on Cumins Diesel Generators
from 500 kva to 1500 kva.
- 1 Answers
- 3672 Views
- Maruti Suzuki, I also Faced
- E-Mail Answers
Answer Posted / kj
It will depend on the controller used.
Most sets have at least-
Low oil pressure,
High engine temperature,
Low coolant level,
Over speed,
Under Speed,
Low AC volts,
High AC volts,
Over current,
Short circuit,
Weak battery,
Paralleling sets will also have-
Reverse power,
Loss of excitation,
Phase rotation,
Synch check,
Braeker fail to close,
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
What is the simplest formula to calculate the rotor diameter of a synchronous generator?
what is the most permissible winding temp when we conducting a generator load test?(condition no load)
in dc series motor if field wdg is shorted then
What is the criteria for selecting the voltage classes of an AC Induction Motor.The KW rating above/below which ht/lt selection is made may be provided in details.
Why should be the frequency 50 hz 60hz only why not others like 45, 95 56 or anything , why should we maintain the frequency constant if so why it is only 50 hz 60hz?
why starting current is high and resistance is almost 0 during the starting of motor dc motor...?
why we take movement of rotor always in counter-clockwise direction in 3-phase induction motors?
What do you mean by per capita requirement of electrical energy in india
what is invertor supply and raw powersupply
why and how voltage sharing in transformer, during magnetic balance test ?
A cotter joint is generally used to transmit
How to calculate phase to phase difference ?
what are different types of electrical windings? i know the distributed winding ,concentrated winding etc but i want some detailed information, in what condition we will use distributed,concentrated windings what are the difference between them which is best, how induced emf changes by using different types of windings 20 hours ago - 1 week left to answer
I have an existing old MCCB. ABB Model SACE, the rating are: Ue = 660 volts, Iu =1250 Amps, 3 poles, Ith (max) =800 amps at 45 deg C. I need a circuit breaker for my 3 phase motors, 380 volts 60 hz. the supplier required the minimum ampacity of the breaker to be 911 amps. can i use this breaker with rating of Iu =1250 amps but Ith = 800amps maximum?
why ct's&pt'S out put called as burden,why compelsary short ckt the secondary of ct's while removing the burden?
