Answer Posted / phani
An Isolating t/f is one in which the primary and secondary winding turns ratio is 1:1 . so it does not either steps up or steps down the voltage levels but it just isolates the source and load connected to the transformer. I think we cannot find an isolating transformer in practice.
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
What is the equivalent circuit of a transformer and its vector diagram?
'documenˁ
A jet of fluid strikes a plate What was the force required to counter it?
What is the function of a neutral reactor.
How to Calculate The Neutral Earth flat design calculation for the Synchronised generator (Gen 1-650Kva, Gen 2-725Kva
which fault is severe and why?between lll fault and lllg fault which fault is severe and y?
what is thermal resistance of PVC Cable.
we use 400/5A ct and 35/roor3KV,/0.1/root3KV,0.1/root3KV pt ratio. What is the multiple factor of this meter.
how to carried out DAR test in 11 KV Alternator ?
How do you select the pickup value of the relay?
If a air condition consume 2.50 to 3.00 amp then how much it will consume in watts if it is running 10 hours out of 24 hours????
why we used ZNO in Lightning arrester.
What are the three types of compensators?
How should i design a 1ph & 3 ph transformer. Kindly let meknow all steps and formulaes related to design from scratch.
How to calculate the volumetric capacity of a oxygen & Nitrogen gas Cylinder if pressure is 145 kg/cm2 & water capacity of cylinder is 67 liters.
