Answer Posted / piyush gupta
4 = Side in Rectangle
4=4
| Is This Answer Correct ? | 10 Yes | 0 No |
Post New Answer View All Answers
Would you please provide me with questions collected for interview regard to pressure vessel, which is in the aspects of welding, NDT, materials and painting? Please send these questions&answers to lgx_jasmine@126.com within 1 week, Thank you for your help. Rgs!
I'm a Mechanical Engineer (2007 passed out) 77% distinction degree holder from anna university chennai, tamilnadu. presently working in a software company, i'm interested in getting my job with Indian Railways. Can any one help me in how to know the vaccancies and applying for RRB.
project,planning, equioment erraction &maint format. project,planning&scheduling,bar chart
effect of temperature on stainless steel at temp(500C-750C) in respect of the following properties-required for silencer application 1.thermal conductivity 2.heat conduction 3.mechanical strength 4.temperature to weight ratio with values
What are topping and superposed turbines?
Explain the difference between the flight of a plane and a helicopter?
AFTER OVERHAULING KTA19G3 AND JUST ABOUT TO START ,BUT WE DIDNT FIX THE OIL SUMP AND TEST FOR -WATER LEAK FROM LINER O RING SIDE,THEN WE FILLED WATER AND FOUND WATER LEAK FROM INSIDE OF ENGINE -CAM FOLLOWER SIDE PLEASE GIVE ADVICE TO RECTIFY THE SAME
Hello Friends I had my ONGC test today,but it was very bad.But I would give certain suggestions so that u may not face he problem which i had. Be thorough with Electrical Technology.Generators.motors stators etc.There are 5 questions on that. There were also good no.of questions from Hydraulic machine and Production technology. Then 3 from Strength of materials.And remember the dimensional quantities.
What is bootrom? And how it works?
What will be the cause of high temperature in one cylinder of D/E?
Define buckling factor?
What are steam turbine parts usually come into damage?
What is short cycling in refrigeration system?
In which reactor the coolant and moderator are the same ?
Dear Sir, i need previous technical question papers, if possible so please tell from where i got these papers.
