Why only 1ph,2ph,3ph supplies are universally used?? Why
not 4ph or 5ph??
Answer Posted / brdganesh
Just my thought We cant make star and delta
conection correct?
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
State magnitude criterion.
Dear sir, In our plant have Station Transformer having capacity,i want to know, why LV side 40 - 40MVA is given? & how we can get 6.3 KV supply from tertiary(i.e. Open delta connection), Vector Group YNyn0 - yn0 +d MVA Rating 80MVA / 40 - 40MVA + 26.7MVA Voltage rating 420 (Tap range +6,to -10)81.25% /11.5KV - 11.5KV +6.3KV
why servomotor motor? where i apply for best output?
how can we calculate the ratio of caustic soda and water in lrs.
What is difference between SMC supportg and Glass Fibre Reinforced Plastic Support.
Can anyone explain me about the capacitor calculation
block diagram of 2 ups system connected in parallel mode?
What are steps to be taken while designing of DYN11 distribution transformer to achieve magnetising balance?
substation+ plc system
Explain with example of functional requirements of protection relay in terms reliability, selectivity, sensitivity
May I know how much values to be set for earth fault, over current and short circuit values at 11kv side? I have 11kv van 1250amps rating. Present it's taking load 80amps?
What is s-domain and its significance?
What are the types of piano switches?
what will happen if the prime mover on the field excitation of the on-coming generator fails?Explain.
sir please send me iocl written test paper in my e-mail account. i'll be obliged to you........ thank u roshan