What is RTCC in a transfomer and specify its function.
Answer Posted / lalit pratap
RTCC full form is (Remote tap change Control) it's using in OLTC (On Load Tap Changer)installed transformers for voltage regulation controll.
Is This Answer Correct ? | 23 Yes | 1 No |
Post New Answer View All Answers
What the difference between three phase contactor (coil 110vac) & three phase SSR (control voltage 110Vac)? May I use contactor in place of SSR?
If I want to lift the water at a height 50m from ground level through two inch(diameter) metal pipe then what is the capacity of motor pump is required? is it possible in single phase supply or not?
orifice sizing how done, checking & selection
Why we are going for converter transformers for DC drives application instead of distribution transformer?
how to select diiferent power transformers of same capacity on no load loss and full load loss by economical point of view.?
relation between power station capacity and voltage level?
PLZ EXPLIN ABOUT CLASS PS CLASS CT .WHY THEY R DESINED AND FOR WHAT PURPOSE?WHY OTHER CT CANT BE USED AS PS CLASS CT? EXPLAIN IN SIMPLE LAUNGAGE IF POSSIBLE PLZ GIVE CIRCIT DIAGRAM?EMAIL-RAJ_SINGH_0376@SIFY.COM
What do you mean by distribution transformers?
How to know any size of cable if there are not written on cable? Answer must be theurical not by experience.
0.5,1,1.5,2.5,4.0.6.0,10,16 square mm electrical wires how much take maximum current in 50htz
Please provided formula for calculate the cable size from step up transformer to M.V panel, run overhead aluminum cables, total load is 5mega watt, total length 900 feet.
how to electrically make connection to ferroli GN2N?
Draw a 230kv two-bus bar system showing the following. 1.Two generators (150MW) each connected through one 15.75/230KV transformers 2. 1 outgoing lines 3. Two 230/130 KV transformers 4. BUS PT's 5. CT
how to Select Lighting arrester? What r the parameters to be considered for the selection of Lighting arrester ?
What is the unit of attenuation?