Answer Posted / vinod kumar malik
At no load, the receiving end voltage of a transmission
line may be higher than the sending end voltage due to
formation of capacitance between conductors and conductor
to ground.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Why is tan-delta test and capacitor measurement done on alternator?
what is the current setting for different relay protection for transformer .
what are the things that can cause a three phase motor to crawl?
in indoor type circuit breakers why only the corner breaker trips specially during cold season. What is the reason.
hello! sir i did three year of diploma in electrical (2007- 2010) and now i m a student of electrical engineering. sir can i apply for germany visa for study and part tome work over there?
In motors how many types of cooling systems were used?
What is acsr cable and where we use it?
what the principle of sincroscope?how it works?when it needed?
What are the properties of a resistor?
hello friend i wish to study a course related to the electrical construction, controlling and monitoring , which course i want to study? pls give me the name of institute?
EXPLAIN THE WORKING OF SERIES REACTOR IN HT CAPACITOR BANKS (FOR VOLTAGES & CURRENTS)
If a air condition consume 2.50 to 3.00 amp then how much it will consume in watts if it is running 10 hours out of 24 hours????
what are the 4 rules to start the motor?
In a Impedance Based Distance Relay (Quad Characteristics) - Could there be two different Line Angle(RCA) for Ph-Ph & Ph-Gnd? If So Kindly Let me Know.. Where, What are the advantages of the same?
What is difference and reason b/w -48V BTS system and 24 V BTS system. Plzzzzzzzzz tel me.
