i want to trigger ATS (Mains +Generator )from external
system could any body help me in this regard ??
is it posible if yes please tell me how?
- 1 Answers
- 2497 Views
- I also Faced
- E-Mail Answers
Answer Posted / kj
If you want to start the generator remotely and change the
load over it is possible.
Some ATS have a function where an external input can
trigger the change over.
If it does not a remotely controlled relay can switch one
of the phase to the under voltage sensing. The ATS will
then think the mains have been lost.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
i am studying in final year can i allowed for 23rd UES of Indian army
what is sevice settings for mccb?How can be it setted?
why do we use 25kv supply for traction purpose?
CT Ratio of a energy meter connection is Red Phase : 100/5A, yello Phase : 50/5A & Blue phase : 100/5 A what is the overall Multiplication factor
3- What is the target from Zero Impedance, Single Phase Imp., S/C Imp. and magnetic balance tests?
What test must you do before powering up a circuit that you have been working on?
what is the use of commutator in dc motor if we supply ac ? commutator is used to convert ac to dc.and it is used to arrange the flux in unidirectional in case of dc supply. if we give ac as supply to dc motor what is the use of commutator?
how to read idmt curva
what's prime importance of protection in electrical system.if protection system don't work properly what can happen in electrical system?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
State the formula for overall efficiency of thermal power station
why HT armoured cable does not glanding
What does a Bode plot tell you?
What are the characteristics of negative feedback?
How to calculate fault level of 11 KV system
