Why dnt we generate 5-ph or 7-ph supply like as 3-ph supply
- 2 Answers
- 3642 Views
- I also Faced
- E-Mail Answers
Answer Posted / kj
Three phase supply is the least number of phases that will
produce a rotating magnetic filed. This allows 3 phase
induction motors to start without special methods as with
single phase.
Extra phases have been used at times but it increases the
costs of all the power lines.
Where 3 phase can be 3 or 4 wire, 5 phase would be 5 or 6
wire and 7 phase would be 7 or 8 wire.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
How can I known multiplying factor .without multiplying table
How to justify this statement ??? "Capacitors in series provide less capacitance but higher voltage breakdown rating for the combination"
detailed procedure how we calculate cost for pcc m10 and rcc m20 including centering and labour excluding steel/ iron
can anybody sent me power grid questions. what subject should i prefer for preparation?
how to CHECK CT AND PT AT THE FAULT OCCUR IN GENERATOR RELAY PANEL .
Where burned of electricity,when,who, & why.
mention hazard experienced during installation
How much ph is maintained of water resistance starter for slipring induction motor ?
how to measure earth resistance of a substation
What if high voltage side circuit breaker of a ehv transformer instead of lvcb? Kindly elaborate.
State angle criterion.
what is the difference between single ratio, multiple core and multiple ratio, multiple core ? please explain.
What is an Air COmpressor
What is measurement?
lorteny method
