Interested to Buy Any Domain ? << Click Here >> for more details...
How to work DCS? how to get the signal from Field
Instruemtns to PIB to Console?
- 2 Answers
- 11753 Views
- Alstom, Invensys, I also Faced
- E-Mail Answers
Answer Posted / unlucky
DCS operates with HIS connected with FCS through controlled
communication bus
dcs generally receives signal from transmitters(field device)
and with the help of this and engineering station it will make
any control action they are connected through ethernet and
vnert cables
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
What is the diffrence between digital signal processing and discrete signal processing?
Explain the working of an electronic level troll.
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
how is work pressure switch& level switch?what is the principle of this?
Instrumentation Safe Guarding test. How to determine the interval time of the test. eg:Halfyearly,Every year,Every three years etc.
you must show the examples application and give at least 4 types of transducer/sensors that can minimize the failure during the manufacturing of the resistors.
why would you like to join our company
What is the use of single seated valve?
If we increase only P what will be controller action ?
What is the difference between mmwc and mmwg?
What is three element drum level control system why its better than single element?
if in a level tx height is given, how u calculate the ranges of the tx?
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
the whole paper was based on Transducers..questions like define repeatability, error,accuracy,precision..den there were many q. on the conversion of Pa to mmHg and other units.. also..der wer few Q. on some level sensors(with diagram)
Tell about your IFFCO plant visit.
