what is DG synchronization panel
plz explain the working!!!!!!!
- 12 Answers
- 93524 Views
- Kirloskar, Lanco, MPS Techologies, Sedemac, I also Faced
- E-Mail Answers
Answer Posted / m.rajkumar
Dg Synchronization panel used to 2 or more dg sets.
because load sharing perposs.
first master dg start upto 70% load increased to another dg will start that time voltage,HZ,RPM its to match only two dgs syneh.
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
Should power factor be low or high?
What is the tipical Online UPS input voltage for 20 KVA load ( 3 Phase or 1 Phase )? Why ? Explain it...?
How to calculate impedance volt in Transformer?
What is effect on in zone and out zone fault if CT chosen for phase side is Vk/2<5mA and Neutral side is Vk/2<15mA on REF protection of Transformer
why steady state stability limit is greater than transient stability limit ? How it can be explained ?
what will happen when the dc supply is given to the capacitor?
I want to calculate how much capacitor we connect to maintain the unity power factor? Is there any formula? Pls give me the answer
How to measure the Harmonic Distortion of UPS ie THD?
Enlist four components of electrive drives.
What is line resistance of cable & how it can be measured ?
What is difference and reason b/w -48V BTS system and 24 V BTS system. Plzzzzzzzzz tel me.
what is the defination of Cable database? What are the points are considered while preparing cable database? Is there any sample available for cable database?
Why Stabilising Resistor used in REF circuit ?
What is value of earth resistance required for substation and equipment earthing and what are the reference guidelines
can i use ups power as a raw power for another ups
