what is full form of SMART
Answer Posted / amit jassi
S-pecific
M-easurable
A-pplicable
R-ealistic
T-imely
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
why we use the ac supply load cell>?can we use the dc supply load cell?advantages and disadvantage of the ac supply load cell?
What is difference between Ionization heat and bimetallic heat
I am using 971 Enraf radar level transmitter for LPG tanks ,the tank side indicator gives the error code 999999999FL can any body give me any diagnostic for this issue?
how do calibrate the valves.. with clear manual
what is the process to make control schematic ?
Which types of quections asked in interview for FORMULATION PLANT (PHARMA)
Good evening all I need a small favour regarding reliance paper i wanna probable sample papers(e&i) of reliance. if any of u have any idea about dis then plz mail me back.i belongs to electronics and instrumentation engg.so i need e&i papers. thanking u....
what is thermo coupler and how it works
what is function of SCADA , and how is it work, explain with difination
what is the usage of QDV & VOLUME BOOSTER
what is function of switch, and how is it work, explain with difination
the 3 most common transmitter protocol being in refinery or qatar gas and aramco.
What are different types of valves?
Explain the combusion chamber