A 12.5 hp slip ring motor taking high initial current and its MPCB is
getting open.what may be the reason?
- 3 Answers
- 4160 Views
- I also Faced
- E-Mail Answers
Answer Posted / kiran
what will be the motor rating and weather it is connected to load or no loaded...?
if there is no load then check for motor,
if it is loaded then check for mpcb and also check for mpcb is good or bad..then replace new mpcb of proper rating..
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
can the measured percentage error during calibration of single phase energy meter be negative?
If not into production, how far did you follow the design and why did not you see it into production?
Dear all, I'm manikandan I have done by DIPLOMA EEE from 2011 , I have 5 years of experience from Power plant instrumentation field , which one field is give long life & which one field is best ,I confused a lot and also I'm studying AMIE, can I choose which department from Section B examination? pls tell me
A d.c. Shunt motor is found suitable to drive fans because they require?
i have 500 amp inductive load of motors ,,,pleas tell me how can i calculate for capacitor bank for improving my power factor to 99 .....calcullations for capacitor bank,,,,
What is the tube exial fan?
What is the Load Capacity of Panther conductor (0.2) and dog conductor (0.2)
What is transient response?
What is meant by system?
How to calculate that clean water supply in one Day from 150 KLD STP?
how can i find ct ratio of meter by seeing name plate of meter and how it should be used in MF calculation if it shows only-/1???
What are the main faults of DC generators?
Working of microwave oven?
Draw the vector diagramme for Asynchronous Induction Generator at noload,half load and fullload.
in ring main system we use the isolater b/w transfer bus and main bus if we r not use isolatar than wat will be the effect in our sys.
