Interested to Buy Any Domain ? << Click Here >> for more details...
What will happen if 33 kv is given to a 11/0.415 kv Distribution transformer?
- 2 Answers
- 5364 Views
- SECL, I also Faced
- E-Mail Answers
Answer Posted / ifthekar
it will burnt out ,bcz pry windg is desined for 11kv , the
insulation burnt out
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
how does the terminal voltage of transmission lines increase when a capacitor is connected???? This happens not only in transmission lines but also in all circuits. How??? When a capacitor is connected in a transmission line, capacitor also takes energy from the same supply. But how is it able to increase the terminal voltage??? Practically What sequence of events happen during increase in voltage???
how to test power transformer.YNd11
what is resver in electrical enginnering with answer
What is BusBar integrity test and how it is conducted?
Define end float in a motor?
how to caculate cable size for diff types of loads? if anyone know the calculating procedure please tell me
what is deffrence between squirral cage and wound rotor in IM?
why industry prefer ht motor instead of lt motor.
how we control automatic generator i'e with to supply (main supply and local generator) when the main supply was break to supply the local supply automatically to begin supplying power.I now this control circuit is the combination of contactor time delay contactor switch and overload relay .but my question is how we combine those component thank you
What is the pro & con of having 11kv & 33kv incoming, and what is the adv & disadv. of converting from 11kv to 33kv.
what is the best method of grounding in 30 MW generator?
11000volt DG set carnt kaise banvay
why the active power flow of some line is increased when the active power of out is cut ?
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
How to calculate or formula to calculate rhe power in 2 phase system ??
