Answer Posted / arun kumar.k
Generator is produsing the power supply and it is flow of
electron it in form of VA
AND they have own rating and they have own power factor
In motor we calculating the efficiency
>efficiency it always in watts or workdone
>And WE cant relate kva to the load
LOad it s only carry the kw Because load only utilizing
the power and we want to exepcet the load only efficiency
or Work done
>load is only for power utilizing
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is the Diff. btw Manule Pull Station & Manule Abort Station Switches used in FM200 System??
What happen in ups if phase reverse?
how is calculated the quantity of weight in hot test xlpe?
Is there any abbrevation for STUB in Stub bus protection
What is different bewteen low or high impedance busbar protection scheme
In ups static switch if i gives the supply at output end it will open the circuit in stactic switch or not if it will open then how it operates.
What is the difference between Delta & Wye windings?
how generator load test is conducted?what are the steps?
ratings of lightning arrester
What type of fittings and electrical accessories can be install in radiation area ?
could you measure current in parallel?
how circuit breaker work.. what is the operations taking place inside a circuit breaker when an overcurrent occurs... is it similar to fuse?
How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
can we use ZNyn11 transformer instead of Dyn11 transformer in distribution for effectively eliminating harmonics from the industrial loads.
