Interested to Buy Any Domain ? << Click Here >> for more details...
What is difference between loop and zone ?
- 5 Answers
- 14025 Views
- Adgas, Bilt, I also Faced
- E-Mail Answers
Answer Posted / veerabharathi m
zone is the hazardous area
loop is the connection of the intrument from field to whatever system it is connected
loop may be a close loop or open loop
loop means that teh full circuit from sensing element to control valve through dcs, this loop
instruments is located n particular zone, zone is classified harmful things which mix with air and other chemical o2, n2, h2, etc
| Is This Answer Correct ? | 11 Yes | 2 No |
Post New Answer View All Answers
How u measure the massflow in orifice flow measurement techniques
Boolean algebra
how to work static pressure sensore how to work dpt
for oil & gas industries which zone is normally preferred? why? give its example?
what step is taken for ESD ( emergency shut down) in DCS REPLY to hashimka20009@gmail.com
Isometric drawings are generated during _________________ phase of a project
How to calibrate radar type level transmitter for interface level? Total liquid(liq.1 and liq.2), level both the liq individually? For. Both the liquid levels how the signal will go from transmitter to dcs? How to calibrate. Single radar 9:26:55 AM for 2 different liquids in a tank?
What is ultrasonic flowmeter?
what are the use of belew gear in general ??
Which topics are covered in Process Control?
i hav applied for the post of engg. in iocl so please require the past test papers fro instrumentation engg please please help me and send me the papers or tell me the pattern and type of ques asked in examination......
what is RTV function in in process control?
how to measure draft pressure in transmitter pl. give its single line digram
what is controlling card in dcs? how u measure dcs memory?what is bus in dcs?how u know dcs speed n ehternet speed?
I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.
