What is the basic diffrence between Electronics &
Electrical engineering
- 13 Answers
- 14512 Views
- I also Faced
- E-Mail Answers
Answer Posted / subodh kumar
Electrical Signal pass only in conductor or semi conductor
But electronic signal pass Without wire (wireless)
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
For some transformers we are using solid neutral earthing while some others we are using resistance earthing why ?
If 22 KV HT line, Current transformer is 25/5 then how to calculate multiplying factor.
what is the minimum winding resistance of 30hp compressor, to run or to switch on
what is sevice settings for mccb?How can be it setted?
Merits & Demarits of Oil circuit & Air circuit breakers ?
What is block diagram?
1.why are not using acb 33kv ht side? is there any problem 2.what is difference between acb,vcb,sf6 breackers? 3.what is the function of invertor and convertor in ups?
What are different types of control systems?
When will you multiply and devide with derating factors to the actual value while sizing the cable?
in Contactor opearation Why there is a difference in the values of the operate and release voltage in case AC supply
What is CCT (Correlated Color Temperature) ?
FOR 16/20 MVA 132/33 KV ONAN/ONAF TYPE TRANSFORMER IT IS DESIGNED FOR 16 MVA WITH ONAN CONDITION.IT BECOMES 20 MVA UNDER ONAF CONDITION.LOAD LOSS IS GUARANTEED FOR 65KW AT 20 MVA AND % IMPEDANCE 13.75. PLEASE TELL US AT WHAT LOAD LOSS AND % IMPEDANCE IT SHOULD BE DESIGNED FOR 16 MVA AND WHAT WILL BE ITS EFFICIENCY AT 20 MVA?
What are operating procudures & Safety precautions to be observed while operating OLTC in manual mode ?
Difference between control junction box (cjb) and power junction box(pjb)?
What is the comparison of PILC and XLPE cable
