How many safety of Disel Generator

Answer Posted / sheikh

High water temperature, over load, under voltage, over voltage,over speed, engine bearing temperature,

Is This Answer Correct ?    4 Yes 0 No



Post New Answer       View All Answers


Please Help Members By Posting Answers For Below Questions

at meter room 50 hrc switch installed,but there are not get earthing proper,so what happen?and 11kv transformer out put going in to hrc main 400a three nog each? so earthing is require for all switch? (some customer made earthing at there home.)

1470


if 6 earth pit value is 1.5 ohm then what should be the number of earth pit to make the value .8 ohm

1708


th how could we differentiate between armoured copper and armoured aluminium cable what is the basic application? why we prefer the armoured copper as compared to armoured aluminium.

1469


Motor,transformers,capacitor tubelight etc....

1216


if a 3phase 100kva distribution transformer , 400 v,50 hz, 4-wire system is loaded at 160 k.w mostly 1-phase Lighting & Airconditioning split a.c load what will be the net effect on the power system in terms of voltage, powerfactor, current , efficiency of xformer

1472






What is the basic principal, by which DC voltage level is increased more than the supplied AC voltage during conversion. As upto AC level it is contorrled by firing anlge but after maximum level how is it possible.Please clear picture. OR we have to supply the higher level AC?

1477


plz explain the auot-reclosing circuit in electrical engineeing

1915


What is A check, B check, C Check & D check for a diesel Generat

1580


why do you add the load short circuit impedance when considering short circuit amperage. It seems that you should only consider supply. If you need to consider loads and you don't know what loads are to be added , what would be a good sub-transient reactance rating for the loads?

1399


1.4 What is meant by CT knee point voltage and how would you determine it

1162


How is the resonant peak, resonant frequency, and bandwidth determined from nichols chart?

667


Why the dc voltage drop during starting of emergency lube oil pump? The Voltage drop from 135kv to 125 kv for one min. before re-establish to 135kv?

1796


please give some hindalco placement papers for written exam

1354


how to measure earth resistance of a substation

2745


What is the effect of pd controller on system performance?

645