why high current produce in case of transformer when turns are
internally gets shorted.

Answer Posted / syed mudaser ahmed

In case of step down transformers secondary winding is more than primary winding , so on the basis of amount of secondary winding burned the voltage transformation gets increased from primary winding to the secondary winding.

Is This Answer Correct ?    2 Yes 7 No



Post New Answer       View All Answers


Please Help Members By Posting Answers For Below Questions

how many synchronous motor are there in any power plant

1484


one electromagnet is called

1428


what parameters are should nessary for control technic dc drive(in rolling mills)?

1515


what is the eight bit unit?

1972


what is the safe meggar values for motor, transformer HT, LT and Cables? IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load capacity bay to be replaced by 400 mw capacity bay.other than CT(1200/1) what are the other equipment i have to replace. why we generally use 3.5 core cable or in other word 1/2 core for neutral and also confirm me that in balance conditiob(3 phase)current in neutral will zero

1811






what are the safety measures of induction motor?

1584


what is smart grid? why we use it? explain in detals bcoz i want give presentatin from it....

1487


What is current divider rule (cdr)?

831


How relay works, reverse relay, master relay, os relay, earth fault relay and what is its setting point

1203


how to calculate insulation level of transformer?

1098


how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.

1744


what is the reactive power what is the use of it in system

1625


WE ARE PLACE A NEW 75 KW MOTOR FOR JPF.IT IS CONNECTED IN M.C.C. WHEN WE ARE STARTING M.C.C.INCOMER IS TRIPPED.THEN WE ARE CONNECTED IN P.C.C WITH A MM30 RELAY PROTECTION THEN WE ARE STARTED MOTOR WILL RUN SMOOTHLY.

1630


If anyone would like to know or practice for FEWA papers contact me on mohamedrashad2@hotmail.com Just completed the supervisor exam in April 2021

727


show the single line diagram of star delta starter with single phase preventer

4107