Is there any difference between the electronics and communication engineering and electronics engineering?
- 1 Answers
- 2671 Views
- I also Faced
- E-Mail Answers
Answer Posted / anthony p
Communication like other electronics are the outcome of
electrical principles.
Electronics Engineering deals with the electrical aspect of
the equipment.
Electronics and Communications Engineer also deals with the
electrical aspects of the equipment, but uses those same
principles in relation to transmission and receipt of
remote signals.
Basically they are the same, but with the emphasis in
communication, such as: wave propagation, VSWR, Frequency,
Modulation, Wave Length, Receive AND Transmit Signals
(dBm), etc.
I have been in this field for over nine years now, haven't
been to college yet, and still love it.
Some electricians or electronics technicians do not like
working with wireless signals because it is not a 'physical
aspect', and will go as far as hardwired networking
equipment.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
In micro controller individual pin output current is 1.6ma .Normally to blink a led we need minium 10-12 ma. But if we connect led to the micro controller pins without additional device it blinks. How it is possible
What is race around condition in a jk flipflop? How it can be avoided?
Draw and explain a mod-10 counter.
In a UPSR what is the limit on the number of nodes that form the ring?
Sir, Plz send the last 5 yrs ques papers for Railway board's section engineer post. Thanks, c_k_chand@yahoo.co.in
Explain how to design a software ic using vhdl?
Why doping is done in semiconductors?
What are the test parameters to check the proper functionlity of TCP/IP protocol.
Please, give me the simple circuit dig. for "oscillator with variable frequency & upto 6W". I will be very thankful to you.
why the hysteresis is necessary?
Explain why the input impedance of op-amp is so high?
why interrupt is necessary in microprocessor?
What are the advantages of using a fet instead of a bjt?
what is the limitations of hotel management project in .net?
equation for pid controller?
