what are the changes made in induction motor so that it act
as induction generator
- 4 Answers
- 5588 Views
- APPSC, I also Faced
- E-Mail Answers
Answer Posted / alex
a prime mover would be installed and drive the motor above it synchronous speed, it eventually turns to an inductive generator.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
if grounding is notdone at regular intervals for long distance transmission, will the load connected at distribution end receive voltage during negativehalf cycle of the sine wave?
what is the difference between linear choke and suction choke?
Explain the different regions in frequency response?
If anyone would like to know or practice for FEWA papers contact me on mohamedrashad2@hotmail.com Just completed the supervisor exam in April 2021
why the perameters of secondary circuit are more important then that of the primary circuit of induction motor?
How much current will a 5 HP delta connected motor at no load will take?Is tat need a starter
WHAT IS MEANT BY OVER EXCITATION IN GENERATOR TRANSFORMERS? DESCRIBE IT.
Y phase plates are used in transmission line??? what is there need???
why a tester wont shock while testing the power in house
i karmveer bharti persuing b.tech . plz send me syllabus and name of reference books. for preparation of section eng.
List the advantages of star-delta starter with induction motor?
What is the settings of distance protection relay in 400 kv line
I have a current transformer with 1 main reading meter with transformer outside the building and a control panel having 5 CT reading meters with black round coils inside the building. I want to know, A) when current pass through the Transformers, will the current be reduced or be the same and after that B) when current pass through the CT meters with black round coils, will the current be reduced or be the same. C) in the above process will the reading of the main meter be same or different, from the total reading of all the 5 CT meters.
we have earthmat at 110KV substation.we would like to take earth resistance.b some says that by connecting earth megger terminals (C1,P1) at middile point of earthmat (at riser) will cause voltage gradient at other earthmat nods and dont get exat earth resistance.when connecting at end nods will get exat value . is it correct .please explain
what percent do you derate your copper wire when you change from copper buss to copper wire
