what is the difference between earthing and grounding?
- 6 Answers
- 8445 Views
- Bhel, Wipro, I also Faced
- E-Mail Answers
Answer Posted / devsingh boda
Grounding: Connecting the live part (part which carries current under normal conditions) to the ground (earth).It is done for protection of devices under fault conditions.
EX: Transformer neutral
Earthing: Connecting the dead part (part which does not carry current under normal operating conditions) to the ground. It is done for protection of operators who operates the device.
| Is This Answer Correct ? | 13 Yes | 0 No |
Post New Answer View All Answers
how to select diiferent power transformers of same capacity on no load loss and full load loss by economical point of view.?
we have 3 single phase transformers. how will we generate 6 supply from 3 phase supply input
how to calculate IR value of 33KV cable ??
After taking shutdown of 11kv feeder, if you see 5kv by phasing stick in the cable side, is it possible to close earth switch in cable.
how we decide wire gauge for ac or dc coil and what is the basic diff. B/w these two coil?
Saving in copper achieved by converting a 2 winding transformer in to an auto transformer is determined by A voltage transformation ratio B load on secondary C quality of core material D size of transformer core
wHAT IS CAPACITANCE LATCHING? hOW TO CALCULATE CAPACITANCE LATCHING? hOW TO SOLVE THE PROBLEM IF CAPACITANCE LATCHING APPLIED?
7- What is the Dissipation Factor and the difference between it and Insulation Resistance Test? 8- What is the task (function) of DC and AC reactors in power plant? 9- What is the task (function) of (open delta with earthed) in some types in transformers? 10- What is the base of the selection of the vector group in transformers? 11- What is the zig-zag transformer and its function by drawing in large detail? 12- What is the polarity ? 13- Why we make short between phase(R) in high side and phase (r) in low side in vector group test? Where High Side ( R ,S and T ) and Low Side ( r ,s and t ). 14- What are the time on delay and time off delay? 15- What is the vector group? 15- What is the task (function) of different types of vector group such as Dyn11 , Dd0 , YNd1,……..,?
What is the drawback of class b amplifier?
What are stable systems?
why most of junction box vendors providing T5/T6 Temp class jb's for T3 area any special reason?
what is vtg limit of earth and neutral at transformer side?
A 100W electric lamp is supplied from a 115V, 60HZ source. The peak instantaneous power dissipated in the lamp filament is
how can found motors folt current ? how can disided circuit breakers caoicity and breaking capicity ?
Refernce currents are to be generated using refernce cueernts how can this be done??
