Interested to Buy Any Domain ? << Click Here >> for more details...
why synchronization done in clockwise direction?
- 12 Answers
- 26183 Views
- Hindalco, NTPC, I also Faced
- E-Mail Answers
Answer Posted / vikas wadhwa
In my point of view; in modern turbo-generators there is
already provision of about 5% automatic load command as
soon as gen. breaker is closed thus leaving no chances of
gen. tripping on reverse power. Hence, it will not make any
difference technically whether syncronization is done in
cloclwise or anticloclwise direction.
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
DC transmission
Should power factor be low or high?
.php|
why the rotor current becomes in steady state during high slip region? please verify with equations.
if an insulated power and control cables of a running gas diesel gensets laid direct in an open trench i.e, trench bed is not rcc of a power house in which rain water, spillage water alwas exists and all power control cables remains submerged even when gas gensets of 480 kw each runningin on load. These power &control cables runs from power house to switchgear room through these trenches in which water remains most of the time. pl explain its merit & de-merit
Can we test the alignment of End shield and stator of turbogenerator without rotor insertion? Also how to fix maintain the alignment at site installation?
is all the servo motors having brake?please specify which servo motors having brake for stop on position and which are not.
how we can come to know that motor winding resistance which showing by DMM is right or wrong???is there any chart or something that we will compare & check???
What should be the length of transmission line so that we can see/obtain the full sine wave of voltage??
what is your majour contributions in your present job
What is the power requirement of tamil nadu for one month?
How will you justify IR value and Charging voltage of any motor,transformer and Cables.......???? . . . . . . . . Plz tell me any body Baljeet Singh, engineer_89@refiff.com
1. Can a 12v DC choke operate a 60v/12w PL lamp ? 2. Can a 230v ballast fire / operate a 60v/12w PL lamps.
low frequency protection why recomend?
Is MEN and RCD related to each other ?? IF yes then how??
