Answer Posted / kripa shankar gupta
Cast iron
| Is This Answer Correct ? | 0 Yes | 5 No |
Post New Answer View All Answers
what is milling and types of milling?what is drilling and types of drilling? what is tapering and their types?
What are the causes of main engine Turbo Charger blower side dirty?
State fresh water generation plant made water flow.
How does a coal power station produce electricity?
Is pipe round because it provides the least area to volume ratio?
Properties of F.O. the cause damage on auxiliary boiler.
Sketch the jacket cooling system?
Can any one plz help me to find aptitude questions on UG.NX software??
In Rankine Cycle we use the concept of Tm(mean temperature of heat addition).In actual cycle the efficiency comes as n=1-T2/T1 Taking Tm into consideration it comes as n=1-T2/Tm as T1>Tm so the efficiency for both case will not same for a same cycle. Can anybody explain how it is possible? Advance appreciation for your effort.Thanks
What is view factor ?
Tell me how you are ready to comply with the employment rules and regulations if your CV is considered for employment?
Distinguish between the shear center and elastic center.
pls send the technical question paper
L&T construction mechanical questions
Hi i am riyaz ahmed . i got rejected for first time and i nedd to apply for next time and can i apply in 1 or 2 week . and wt abt my sevies fee ? i should make a new once shill i go with the same and wt docement i should change can u plz help me out and my mail it is royalriyaz@gmail.com
