plz tell me the potential difference between phase and netrul
- 2 Answers
- 4342 Views
- CGL, I also Faced
- E-Mail Answers
Answer Posted / ashok mishra
230 according to IER
and flucation of +-6%
sddiet barwala
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
hi this is hema can anyone mail me previous years questions for the APPSC-A.E.E (in electrical stream.) ......thank u.
How the annunciator works ? How to do its wiring
Benifits of 3ph 4 wire metering over 3ph 3 wire
How to calculate size of HT breaker with the help of Amp (current)? Please provide answers with examples.
How to measure power in 2 or 4 or n phase circuit? Please give me a formula.
Define unilateral circuit?
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
3phase motor can be used as a Prime mover for alternator.
Can Anyone Answer anyone of these ? Q1) why direct SOLUTION of Load Flow Studies in Not Possile ? Q2)Why majority of Buses in power system are load buses Q3)Why one of the buses in Power system is taken as reference bus (slack or swing) Bus ? Q4)Bus Admittance Matrix is a sparce (means it contains some zero elements ) matrix , give reason
What are the disadvantages of hydropower?
percetans
Why it is possible to use PWM with a STATCOM and not with a conventional TCR based SVC
An ISP is granted a block of addresses starting with 150.80.0.0/16. The ISP wants to distribute these blocks to 2600 customers as follows. a) 200 medium size businesses; each needs 16 addresses b) 400 small businesses; each needs 8 addresses c) 2000 households; each needs 4 addresses Design the subblocks and give the slash notation for each subblock. Find out how many addresses are still available after these allocations.
The Howland current source produces a A Unidirectional floating load current B Bidirectional single-ended load current C Unidirectional single-ended load current D Bidirectional floating load current
What range of speed can you get with the field control method of speed control of d.c. Shunt motor?
