Hello, im taking an introduction to PLC..and i'm having a
hard time on creating a program for 2 lamps blinking
alternately with this button characteristics:
1.) One push button (starts upon pressing)
2.) Same push button (when pressed again, will pause the
system)
3.) Same push button (when pressed again, will continue the
paused system)
4.) Same push button (when pressed within 2 seconds, will
shut off the system)
Pls..i know this is just a simple problem for you guys..
Answer Posted / r.sundarraj
First draw relay logic and then given 1)connection from one push button connected through relay common point &take o/p in both lamps from NC via. 2)again press the NC button system pause .
3)now holding purpose taken another 1NO,1NC now system will not run
4)final NC o/p connected off delay timer
system power off
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
IN induction motor pf is increased using capacitors.what will be the effect on motor and system when very large capacitor is accidently installed and pf goes leading.
why we use sinosidal voltage / current instead of others in system?
What is the function of electron gun assembly used in crt?
what is ps impedance test
size of condotory fron voltage level
What effect does a very low impedance have on the Voltage regulation? On the short-circuit current?
What is the principle of HIGH SPEED DIRECT DRIVE MOTOR ?
Is there any guideline say about display of earthing value near to earth pit
What is the de rating factor of cable? What is the importance of the de rating factor in cable selection?
Anyone who can recommend an equivalent to Envirotemp FR3 of Cooper?
in basic 2 phase will short means tripping the power but spot welding 2 phase shorting but not tripping it will welded why.....(Q)
How halogen & merquery lamp works.
i installed 100kva ups. what KVA genset they should provid in input side? plz any update formula or ans with reason.
what is stper motor
What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?