how much the voltage & resistance should be ,between earth
& neutral points.?& why?
- 6 Answers
- 6324 Views
- I also Faced
- E-Mail Answers
Answer Posted / pradyumna chandra panda
the resistance b/w earth and neutral 1.8 kohm is accepted and in 3phase supply voltage b/w earth and neutral 3v to 20v is accepted.
| Is This Answer Correct ? | 3 Yes | 3 No |
Post New Answer View All Answers
electrical
what is a pilot wiring and whys that called a pilot wiers
what is effect of length of air gap on performance of dc motor and generator?
132/66kv sub-station procation ?
what is the affect of earth's magnetic field on the frequency used in aircraft???
to hook up ten 50 amp rv pedastels at a lenth of 600 feet from the service what size will my service need to be and the size of wire will I have to run to each pedastel in series??????
State nyquist stability criterion.
Define active filter?
What is the requirement of grounding the neutral of single phase generators on load? If the neutral is not grounded, what will be the effect?
why there using acb enclosure in big buildings
How to select circuit breakers rating eg. if i select a circuit breakers of capacity 40 amps DC with operating voltage 28 volts and if i what to use same circuit breakers for 300 Volts DC application what is the current rating of this circuit breakers.
Define peak time.
what is the write prosidure of stringing of 8meter pcc pole.
Define average demand?
iam preparing for rrb section engineer post in electrical branch.suggest the right textbook for my reference.fromwhere i will get the previous q.papers?
