how much the voltage & resistance should be ,between earth
& neutral points.?& why?
- 6 Answers
- 6321 Views
- I also Faced
- E-Mail Answers
Answer Posted / koti
voltage should be less than 5 volts (to avoid mal-functioning of controls) and resistance should be below 50 milli ohms.
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
Transmission through a short line depends on
The advantages of Magnetic flux leakage technique over Ultrasonic technique for non distructive testing of material.
Why derivative controller is not used in control systems?
how does commutator convert a.c to d.c?
neutral earth resistance testing is it possible for transformer while in load condition
why motor range is available 22kv,30kv,37kv,45kv and so on? why motor range is not available 21kv,24,25,26,27kv and so on?
what is the effect of change in supply frequency on load angle of synchronous motor,all other parameters remaining same?
What is the basic principal, by which DC voltage level is increased more than the supplied AC voltage during conversion. As upto AC level it is contorrled by firing anlge but after maximum level how is it possible.Please clear picture. OR we have to supply the higher level AC?
What should be the values of settling time, peak time, steady state error, overshoot, rise time, MPOS (Maximum percent over shoot) to keep the system in transient state, to keep the system in steady state ?
What is genrally the % Impedance of a Dg set? How can we calculate Earthing conductor size for a DG set?
I have 2 KW electric water heater.I am gonna use it in controlling water temp.so I needed to increase or decrease the heating capacity.is there any electrical-electronic circuit for varying the resistance & so current?
what is the voltage rating of chiller unit sensors
what is charger supervision and control supervision?
What is the reason for using a GE G101 MCB in place of an EP102 MCB if both are capable of AC circuit protection?
how can i find ct ratio of meter by seeing name plate of meter and how it should be used in MF calculation if it shows only-/1???
