how much the voltage & resistance should be ,between earth
& neutral points.?& why?
- 6 Answers
- 6320 Views
- I also Faced
- E-Mail Answers
Answer Posted / harikesh yadav
voltage and earth resistance 0 to 3 volt acceptable in india
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
What is the loss of power of transformer 220kv/33kv,63/80mva of % imp12.05 at 80%load
what is the purpose of shading ring or shading coil in electrical equipments.
What is given by the definition in BIL IMP/PF = 950/395 kV. This was found in a name plate of a power transformer.
Explain the working of variable frequency transformer?
What is open delta Xformer? It's adavntages & Use?
Why in metering Ct for ammeters ct secondary side is grounded for each Ct but not in case of CBCT (Core balance current transformer)..kindly some1 highlights the reason..is it because net flux is zero?
What is Phase to Phase clearance for 800V System Operating Voltage as per IEC61439
To prove the capacity of a 10MVA transforemr with 6.5% impedance by a short circuit test how much power is needed to inject an impedance voltage if we have to arrive for its rated current?
In DC generator, we use commutator, having no. of segments. Then how it is possible to get a half wave of voltage and current for half rotation of armature?
How to dimensioning SDCCH, LAPD and CS7 signaling on GSM?
what is the difference betweem star connected motor & delta connected motor?
How i can decide that HVDC line is best for transmission.
Dear all, I'm manikandan I have done by DIPLOMA EEE from 2011 , I have 5 years of experience from Power plant instrumentation field , which one field is give long life & which one field is best ,I confused a lot and also I'm studying AMIE, can I choose which department from Section B examination? pls tell me
which of the following elements is not present in stainless steel
Is vtg is controlled by the resistor? if else how much?
