Answer Posted / mohana sundaram
Over speed , Low Lube oil , High water temperature , Over
load, High voltage, Oil pressue high, Air filter choke
Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
How a capacitor discharge weld power supply works? what is the use of a pulse transformer?
WHAT IS DIFFERENCE BETWEEN MANUAL CONTROL AND MAGNETIC CONTROL AND STATE ITS ADVANTAGE /DISADVANTAGE
how line turns ratio changes in 3 phase with change in connection
how much UPS neutral erath leakage current.
how can we change the phase angle b/w two phase?
In electrical what is earth(ground)connection, wht is the importance of it, why it is recomended to maitain below 3VAC between Neutral and earthspecially in PLC used machines?
How to design the NGR Resistance
What is VCB? where it is installed at SP. What is SP?
In case of HV test on medium voltage cables, BS is asking for 4 U0 where as IEC is asking for 3.5 U0. Can any one advise me how this 3.5 times or 4 times U0 is derived?
How to calculate VCB rating for 33KV ,25 MW Power line?
What are reasond for high wattage in single phase induction motors
Can any body tell me the different types of LT cables & their application.
how make megger test for control cable like 12c x 1.5mm and what it apply voltage and test timing details.
what are different types of electrical windings? i know the distributed winding ,concentrated winding etc but i want some detailed information, in what condition we will use distributed,concentrated windings what are the difference between them which is best, how induced emf changes by using different types of windings 20 hours ago - 1 week left to answer
What is safety of Ht panel