in how many ways we can make induction motor to run in
reverse direction?
- 5 Answers
- 5713 Views
- I also Faced
- E-Mail Answers
Answer Posted / hemant
In 3 PHASE type of induction motor we need to change only a
phase sequence of incoming supply so its sequence of phase
angle get change(0,120,-120 electrical degree) is
responsible to change electrical field produce by phase
hence direction of induced emf get revers so and so its
rotor rotate in revers direction, in case of single phase
motor diection may change by changing capacitor terminale
which across to supply voltage.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
I am going to appear for the RRB Chennai junior Engineer online exam. Please send me the previous exams question papers (also solved) to my mail id: rrkhandhar@yahoo.com
sir, i am 3 years diploma course pass out candidate.what type of certificate can i got in marine service.
Whether amorphous core transformer is available in India?.If available then up to what rating of voltage and KVA?.
what is the interrelation between voltage current torgue speed and magnetic flux in case of different types of electric motors
What is the count of hvdc transmission lines in india?
what would u consider to be the basic purchase order information you would need to proceed with a cable inspection assignment?
hi i will D.E.E.E.is completed pls send rrb diploma old qustion papaer sent in my e mail. i.d.
What the formula for calculating no.of earthings & size of earth strip for 100mX90m shop.
how we design a pannel to start 10HP motor with the help of star delta starter?
Do you need any help with FEWA Electrical Supervisor exams?
pls tell me function of closing coil of A.C.B.
who invented active elements? plz give me the complte details of active elements...
being an electrical engineer why you wanna come into software i have an very good academics what answer i have to give
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
When calculation of fault current and fault Kva is to be done,why always we use per unit value and why we consider the base kva?
