What are the functions of grout inside tendon ducts?
- 3 Answers
- 5586 Views
- I also Faced
- E-Mail Answers
Answer Posted / pandiyarajan.r
1.to avoid the hogging
2.to avoid the lateral , longitudinal buckling
3.to prevent from corrosion, slip of tendon
4.for maintain the tension in tendon
5.to increase the friction force between tendons and ducts
to maintain the tension fore .. if friction fore reduced
some time tendon will go back original position which means
no fore in tendon it leads structural failure ..it will not
take load.. etc
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
How do you calculate reinforcement weight of steel?
how much quantity of cement,sand and water required for 1 sq feet flooring work .
how much required strength of cement concrete bricks(size 230x115x75mm)
What is the worlds largest concrete dam?
how to find out hard strata in bored pile when the DMC method adopted.
how much cement is consumed by a stone masonry wall 17.7m long,0.55m wide and 1m high
What is the standard rate of installing ties for column(60cmx60cm) and beams(50x850)(weight)
How are freeway bridges built?
sir I got selected in rail vikas nigam limited and they call for interview but i don't what they will ask in interview please guide me if you have any experience
PCC Road Min Grade M 30 for VR standard Mahatashtra load 30 KN. what should be thickness of pavement, width 4m what should be length of panel.
What is the significance of cost estimate knowledge for an architect?
for 16mm thick cement plastring 1:6 on 100 Sq.m.New brick work,the quantity of cement required is.
silt%= silt volume/ silt+sand volume is this right?
where will be the reinforcement of slab placed when there is an inverted beam and the bottom of the beam and slab are at same level ?
How to calculate paint drums per meter square
