Interested to Buy Any Domain ? << Click Here >> for more details...
i have calibrate rosemount make level transmitter , wht
can i do ? my tank capacity is 30,000 liter
- 9 Answers
- 18001 Views
- Equate, I also Faced
- E-Mail Answers
Answer Posted / hakkim pa
measure the tank height make sure which liquid is using inside the tank.
formula : height X density
suppose your tank height is 5 mtr convert it in to mmH2O
its come to 5000mmH2O
if the liquid is water,density is( 1 )
URV= 0 X 1 = 0
LRV=5000mmH2O X 1 = 5000mmH2O
it is a hart type use communicator & enter the data
manual calibration measure the mm on the 0% and turn the zero potentio meter until it reach 4 MA
fill the tank up to 100% and turn the span potentio meter until it reach 20 MA
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Emergency Shutdown Systems/ Plant Shutdown System.
why fuse block is not used for AI signal?
Draw a simple circuit for a well head control panel used to protect the well against fire, leak, blockage, ESD, & controls the operation of one downhole & one surface safety valve. Explain the operation and controls
while am calibrating Drager polytron 2IR flame gas detector occured non zero status.how can i get zero status?
How to find out the current of two motors having same power consumption but different RPM?
send me model hpcl questions pleas..........my mail id mohideen.dharvesh@gmail.com
Explain about safety integrated level protection? . How it was differ from other protections ?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
Give Detail information about plc,dcs,and scada system?
what is the protection system in solar turbine compressor
What is zone,loop/fire alarm system?
what is thermo coupler and how it works
What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.
why any measurement made interms of pressure is more accurate ? to be more precise most of the flow velocity is made interms of pressure and it is accurate. what is the reason behind pressure measurement being accurate ?
What is mean by analytical instrumentation?
