If DC supply is given to a transformer it may
a) Work
b)Not Work
c)Give lower voltage than the rated voltage on secondary
side.
d)burn the winding
- 12 Answers
- 13297 Views
- wbsedcl, I also Faced
- E-Mail Answers
Answer Posted / prasenjit biswas
d)Burn the winding.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What does the kvar means?
Why computer humming sound occurred in ht transmission line?
State the methods of improving power factor?
what is the common earth
what is the use of piston rings in the engine used for a generator...........
what is the criteria for selection of conductor used for ehv ac electrical dischrge
Please brief what is sinewave
IF alternator SCR value will be high means what happen in alternator efficency at operating power factor of 0.8
what is plunger and what's the use of it in motor alignment?
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
I have c license but I don't know eligibility of Max Kilo Volts under the electrical licensing board.
I have a relay contact rated at 220v dc which is supplied with a 24vdc from the panel,for it to trip the dampers(24vdc).What if the application of the relay changes so that it should work at its rated 220vdc then will it work at 24vdc supply given or any other consideration needs to be taken .....
What is cable tray, its type, and its support?
how invertor convert the dc into ac give brif detail
Give some differences between open loop and closed loop?
