Interested to Buy Any Domain ? << Click Here >> for more details...
If you touch at the end welding machine, will you have shock ?
- 1 Answers
- 3689 Views
- I also Faced
- E-Mail Answers
Answer Posted / shaheer a p
No, shock is a function of both current and voltage. In
welding machine voltage level is low.
| Is This Answer Correct ? | 9 Yes | 1 No |
Post New Answer View All Answers
WHAT IS THE TOTAL POWER GENERATION IN CHHATTISGARH?
Explain about how is it working Earth fault'relay and wahts the resistance value of earth bed
What is the actual meaning of thermal power efficiency ?
What was your role in the silicon evaluation/product ramp? What tools did you use?
How does cost of generation from hydropower plant compare with other sources of electricity?
What is fault clearing time for Current Limiting Moulded Case Circuit Breaker?.
how to calculate the distance relay faulty zone?pls explain?
How the PF control while running DG set with load
What aturn on methods of scr?
What are linear and non-linear systems?
define the active power?
when generator short circuit condition, the current how dissipates. or at short circuit voltage not available then current how can flow?
How we can defined theecopper cable size if we know the aluminium cable size?
direction of tarbine& genrator
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
