Answer Posted / nandhini
its a electronic device which is used to convert data or instructions from one form to another like analog to digital.it also perform like a multiplexer
| Is This Answer Correct ? | 6 Yes | 3 No |
Post New Answer View All Answers
what are the usual topology of transformers at different substations in the power system and why that particular topology is choosen. what are the limitaions of that topology?
What is stepper motor. What is its uses?
Hello Friends, How can we recognize the CT Star Point is S1 or S2 in case of Electro Mechanical Relays and what is meant by Restraining coil in relays and what is the purpose of that.. thank you in advance..
Dear Brother can u tell the proper size selection of cable & the fault level calculation of braker, busbar etc. pls mail me at azeemk30@gmail.com
What is “pu” in ee?
what are the major & minor faults that occur in an inverter and in UPS ? And how to repair and resolve them ?
In 11/0.414 KV Parralel supply network with Bus tie closed what will be the fault level is it doubled or halved??
What is the difference between Droop vs Isoch Control?
what is cascade speed control device?and how this device control the speed of motors?
what is a pilot wiring and whys that called a pilot wiers
In radial network the source is fed from 1 end both ends at central
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
A d.c. Shunt motor is found suitable to drive fans because they require?
What is the restart inhabit setting in ABB spam150c relay (Motor protection relay)
i have seen one 8.4 MW synchronous motor in a plant located in bellary it is fixed with brushless rotary rectifier ,anybody can explain its start up principle
