WHAT THE DIFFERENCE BETWEEN THE E1T1 CARD AND RRI ..?
- 2 Answers
- 4811 Views
- NSN, I also Faced
- E-Mail Answers
Answer Posted / agnivesh
RRI used the simple IF connector ,
but the E1T1 used the TQ connector.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
With the help of diagram explain a cmos inverter.
Explain why is the plastic dip ic package most widely used?
What is the internal structure of op-amp and explain each block in brief?
Describe the working of 3φ fully controlled bridge converter in the rectifying mode and inversion mode. And derive the expressions for average output voltage and rms output voltage?
What is effective communication?
What is a full-adder?
Why doping is done in semiconductors?
Why is space region called the depletion region?
what is the function of solid state relay (SSR)
What are the disadvantages of load commutated chopper?
What is the percentage i get to work in MICROSOFT
We are facing the problem of communication failure between seimens drives and ABB DCS. Between drives and DCS on RLM -01 module for communication purpose. We found red blinking i.e error blinking in RLM -o1 module. So we replaced with new one but after one month same problem again came. So again we installed old RLM-01 module. Now also RED blinking is coming but sometimes drives are not tripping. What will be the cause for this problem?
send me test pattern of nsn?
how to design an ups and battery connections for ups .
Why would the files on hard drive stores temporarily but not permanent?
