Interested to Buy Any Domain ? << Click Here >> for more details...
What is difference between PVC cable & XLPE cable?
- 14 Answers
- 198920 Views
- Intertek, I also Faced
- E-Mail Answers
Answer Posted / nagaraj
xlpe cable are used for high voltage application.but PVC
are used for low vlotage application.XLPE cables are cost
vise better one than PVC for high voltage application
| Is This Answer Correct ? | 12 Yes | 11 No |
Post New Answer View All Answers
Can we use 230VAC, 63A MCB for 120VAC, 63A supplied heaters load?
what is transient enclosure vltage , very fast transients, very fast transient over voltages
What will be the voltage regulation of a full load and 0.80 power factor lagging load transformer when a two winding single phase transformer has a voltage regulation of 4.5% at full load and unity power factor?
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
defult setting in p220 micom motor proction relay for 11kv,640kw,f.l.a.-40a,1440rpm ht motor?
how test transfomer(3 phase75kva) by megger
State how to produce a constant rotating field by application of alternating currents to stator armature of a three-phase squirrel-cage induction motor
what are the precuation should be taken ahen installing power transformer,circuit breaker,current & potential transformer
how point on wave controller works.
hi frnds what is meant by harmonics & what is meant by third hormonics,where its will occur ?thank u
how to calculate the fault in substation
How do I calculate/select Droop CT ratio for various capacity of generators?
What is meant by analogous system?
how to select diiferent power transformers of same capacity on no load loss and full load loss by economical point of view.?
what is the effect of un-synchronized power.
