what do we mean by hook up drawing. what r the information we
get from it?
- 7 Answers
- 32152 Views
- Reliance, I also Faced
- E-Mail Answers
Answer Posted / gopi shukla
Hook-up drawing is a detailed drawing showing typical installation of instrument in a correct manner so that instrument operates properly (gives accurate indication and prevent any issued which could potentially affect the measurement such as liquid trap in gas impulse line).
Hook-up drawing indicates tubing slopes, position of instrument in reference to process tapping point, scope break between instrument vs piping.
There are two types of hook-up drawing:
Process Hook-Up
This hook-up drawing contains typical installations for instrument which connects to the process
Pneumatic Hook-Up
This hook-up drawing contains typical installations for instrument which requires instrument air such as control valve, actuated valve
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
What is the minimum rating availalbe for weld neck orifice in market?
how many maximum enter 2mm Dia solid cylindrical pipe into 8mm Dia hollow cylindrical pipe. give answer with calculation.
Positioner usage.
I wnat to practice more online type questions .so will you show them me to take a practice test?
What is heating effect?
What are the uses of orifice plates?
in sulfur process what is material of impulse line we use to connect with transmitter ? and does teflon affected by sulfur?
What is the reason PT speed not incresed in gas turbine?
Make a ladder diagram on LSL valve will close, on PSL valve will open and start the motor
please send the sample qustion paper for iocl written test ..
In turbine, what does term CDP, NI, NH, HSSOC, means
where proximity sensor installed on tank in loading arm application
how to measure oxygen which methods are using?
we have level transmitter for h2s04 storage tank capacity 10k ,always there are failure of transmitter due to failure of magnetic floats ,please come up with solutions at the earliest.
How can i test procedure grounding for CAT-7 cable? Or How can we test procedure CAT-7 Cable Electrically safe?
